Camera Mounting Plate

For Raspberry Pi cameras (Die Casted)

Camera mounting plate for easy installation of Raspberry Pi camera modules

Camera plate with 1/4″ screw holes for easy mounting of Raspberry Pi camera module V2 / V3 and SPRESENSE camera board (CXD5602PWBCAM2W / CXD5602PWBCAM1) on a tripod.
It can also be used with camera modules that use the same 24x25mm substrate as the Raspberry Pi camera module.

① Raspberry Pi Camera Module V2
② FFC Cable
③ Camera Mount Plate VC-MPA

① Raspberry Pi Camera Module V3
② FFC Cable
③ Camera Mount Plate VC-MPA

① Entaniya VR220 Camera
② FFC Cable
③ Camera Mount Plate VC-MPA

The camera mounting plate has screw holes (1/4-20) on the top, bottom, and back of the plate, which are used for photographic imaging equipment to facilitate mounting on a tripod or similar device.
In addition, one side of the plate is angled at 45 degrees to allow installation without straining the flexible flat cable.


Product Na,eMounting plate for Raspberry Pi camera module
Product NumberVC-MPA
Attachable camerasRaspberry Pi camera V2
Raspberry Pi camera V3
Camera module with 24x25mm base
Size30 x 35 x 10mm

Safety wire for drop protection

The camera mounting plate is equipped with a hole through which a drop prevention wire can be threaded. When installing the camera in a high place, it is recommended to use a fall prevention wire for safety measures.

How to install fall safety wires >

About Quantity Discounts

We offer a quantity discount service for corporate customers. If you are considering purchasing in large quantities, please contact us in advance using the inquiry form below. Please note that the discount varies depending on the type of product, selling price, quantity, and time of purchase.