Camera Mounting Plate
For Raspberry Pi cameras (Die Casted)
![](https://e-products.entaniya.co.jp/en/wp-content/uploads/sites/2/2023/12/mount_main.jpg)
Camera mounting plate for easy installation of Raspberry Pi camera modules
Camera plate with 1/4″ screw holes for easy mounting of Raspberry Pi camera module V2 / V3 and SPRESENSE camera board (CXD5602PWBCAM2W / CXD5602PWBCAM1) on a tripod.
It can also be used with camera modules that use the same 24x25mm substrate as the Raspberry Pi camera module.
![](https://e-products.entaniya.co.jp/en/wp-content/uploads/sites/2/2024/02/cameraplate_2.jpg)
The camera mounting plate has screw holes (1/4-20) on the top, bottom, and back of the plate, which are used for photographic imaging equipment to facilitate mounting on a tripod or similar device.
In addition, one side of the plate is angled at 45 degrees to allow installation without straining the flexible flat cable.
![](https://e-products.entaniya.co.jp/en/wp-content/uploads/sites/2/2023/11/cameramount_008.jpg)
![](https://e-products.entaniya.co.jp/en/wp-content/uploads/sites/2/2023/11/cameramount_007.jpg)
Specifications
Product Na,e | Mounting plate for Raspberry Pi camera module |
Product Number | VC-MPA |
Attachable cameras | Raspberry Pi camera V2 Raspberry Pi camera V3 SPRESENSE Camera board CXD5602PWBCAM1 Camera module with 24x25mm base |
Size | 30 x 35 x 10mm |
Mounting Plate and Camera Cover Set
![](https://e-products.entaniya.co.jp/en/wp-content/uploads/sites/2/2024/03/cameramountplate_02-1024x577.jpg)
Set of camera mounting plate and camera cover.
The camera cover makes the camera less noticeable and reduces reflections.
![](https://e-products.entaniya.co.jp/en/wp-content/uploads/sites/2/2024/03/cameramountwire.jpg)
Safety wire for drop protection
The camera mounting plate is equipped with a hole through which a drop prevention wire can be threaded. When installing the camera in a high place, it is recommended to use a fall prevention wire for safety measures.