Cube Case 125 A
Cube-type case with interchangeable panels
Cube-shaped case with 6 panels made of seamless aluminum frame.
Each panel can be freely interchanged, allowing customization according to the application.
Interchangeable panels
Each and every panel can be freely replaced, allowing for customization according to the intended use.
For example, even after a panel has been damaged or a hole has been drilled through a plug, etc., the panel can be replaced and used in the same way as in its original state.
Die Casted Frame
The frame is made of die-cast, seamless one-piece molding for a high-end look.
Acrylic and aluminum panels
Specification
CC125 A Acrylic panel
Cube case with five 3mm-thick acrylic panels and an aluminum panel on the bottom.
5 x 3mm Acrylic panels
1 x 1.5mm 1.5mm Aluminum panel (Bottom)
Size: Outer dimensions: 125mm x 125mm x 125mm
Inside frame size: 95mm x 95mm
CC125 A Aluminum panel
Cube case with six 1.5mm-thick aluminum panels.
6 x 1.5mm 1.5mm Aluminum panel
Size: Outer dimensions: 125mm x 125mm x 125mm
Inside frame size: 95mm x 95mm
Acrylic and aluminum panels are the same size and interchangeable.
They can be used in your preferred configuration of 3 acrylic panels, 3 aluminum panels, etc.
Replacement panels are available for both acrylic and aluminum panels. (Sold separately)
For CC125
For CC150
The composition of the cube case will vary depending on the parts used and other factors.
Please fill in and submit the following estimate form.
If you have any questions about our products, please contact us using the inquiry form below.